Most read articles by the same author(s)

• O. V. Deribo, Zh. P. Dusaniuk, T. M. Horuk, Usage of dimensional analysis for defining minimal intermediate machining allowance in the openings of base members , Visnyk of Vinnytsia Politechnical Institute: No 4 (2009)
• Zh. P. Dusaniuk, O. V. Deribo, S. V. Dusaniuk, Influence of high pressure hoses on the character of transient processes in long pipe lines of technological units hydraulic drives , Visnyk of Vinnytsia Politechnical Institute: No 5 (2008)
• S. V. Repinskyi, D. O. Lozinskyi, O. O. Lanova, M. P. Kucherenko, Mathematical model of proportional electrohydraulic systems of regulated pump control , Visnyk of Vinnytsia Politechnical Institute: No 2 (2013)
• Zh. P. Dusaniuk, S. V. Dusaniuk, O. V. Karvatko, Simulation study of the high-pressure sleeve parameters influence on its rigidity , Visnyk of Vinnytsia Politechnical Institute: No 3 (2004)
• O. V. Deribo, The choice of parameters for the throttling hydraulic motor of the electrohydraulic follow-up vibration drive , Visnyk of Vinnytsia Politechnical Institute: No 3 (2007)
• O. V. Deribo, Selection of parameters of throttle hydraulic motor of electric hydraulic follow-up drive with controlled effort at output organ , Visnyk of Vinnytsia Politechnical Institute: No 6 (2007)
• O. V. Deribo, V. O. Chornyi, Mathematical model of power wiring of electrohydraulic monitoring drive , Visnyk of Vinnytsia Politechnical Institute: No 5 (2004)
• Yu. A. Buriennikov, O. V. Deribo, S. V. Repinskyi, Tools for Automating the Calculation of Hydraulic Actuator Parameters , Visnyk of Vinnytsia Politechnical Institute: No. 4 (2025)
• S. V. Repinskyi, O. V. Deribo, O. V. Piontkevych, Automation of Calculating the Amount of Technological Equipment and Load Factors in Mechanical Assembly Production , Visnyk of Vinnytsia Politechnical Institute: No. 1 (2026)